Appendix DOIT Panel Cutout Dimensions – Front View24 OIT3185A/4185A1010-0104, REV 04Check Dimension 4.00" [101.6 mm]4.50"+/-0.01114.3mm+/-0.
3. OIT InstallationIt is necessary to follow all installation procedures described in this chapter forelectrical noise immunity and CE compliance.Your
3. Route the communication cable to the PLC/host. Refer to the “OIT CableRouting” section for more information.4. Connect the other end of the cable t
3.5. Connect OIT to PowerWARNING Use only with Class 2 power source limited to 30 VDC opencircuit and 8A short circuit.The power cable for the OIT sho
2 OIT3185A/4185A1010-0104, REV 04COPYRIGHT NOTICEThis manual is a publication of Maple Systems, Inc., and is provided for use by its customers only. T
Appendix BAgency RatingsUL Class I, Division 2 Groups A,B,C,D hazardous locations.Environmental Type 4, 4x (indoor), 12European Union Directive Compli
4 OIT3185A/4185A1010-0104, REV 04IntroductionThank you for purchasing a Maple Systems OIT3185 or OIT4185. You haveselected a rugged, reliable, and pow
5.4. Installing a Slide-In LegendTo replace the factory installed legend with your own:1. Ensure all paints, inks and fixative are thoroughly dry and
1. Safety WarningsWARNING Hazardous location environment. This unit is suitablefor use in Class I, Division 2 groups A, B, C and D or Non-Hazardousloc
18 OIT3185A/4185A1010-0104, REV 04“Tick” marks indicateswitch centerlinesCheck Dimension 4.00” [101.6 mm]Figure 9 Photocopy Legend Master2. Control Pa
2.2. Power Supply Selection•The power supply used to power the OIT should have an output between +12and +30 VDC, meeting Class 2 power requirements. T
5. Custom Keypad Slide-In LegendsThe OIT3185 and OIT4185 have a graphic overlay covering the keypad. Thisoverlay contains a clear window that allows y
Commentaires sur ces manuels