Maple-systems HMI5000L Series Manuel d'utilisateur télécharger pdf (Page 5)

HMI5000L Installation Guide 5

1010-1018 Rev 01 www.maplesystems.com

vibration or shocks. Do not install the HMI in enclosures with rapid

temperature variations or high humidity. Either case will cause

condensation of water inside the device and eventual damage to the HMI.

Safety Precautions

Please observe the following precautions when installing the HMI.

Failure to comply with these restrictions could result in loss of life,

serious personal injury, or equipment damage.

Warning: Do not operate the HMI in areas subject to explosion due to

flammable gases, vapors, or dusts.

Warning: Do not connect the HMI to an AC power source. You will

cause permanent damage to the HMI.

Warning: Do not attempt to use a DC power supply that does not meet

HMI power requirements. You may cause malfunction or permanent

damage to the HMI.

Warning: Do not power the HMI with a DC power supply used for

inductive loads or for input circuitry to the programmable logic

controller. Severe voltage spikes caused by these devices may damage

the HMI.

Control Panel Design Guidelines

Pay careful attention to the placement of system components and

associated cable routing. These items can significantly enhance the

performance and integrity of your control application.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Pas de commentaire

Maple-systems HMI5000L Series Manuel d'utilisateur Page 5