Maple-systems HMI5000 Series Manuel d'utilisateur télécharger pdf (Page 13)

13 HMI5000 Series Installation Guide

1010-1005 Rev 05 www.maplesystems.com

Configuration Wiring

To configure the HMI using the EZware-5000 software, you will need

the correct configuration cable for your HMI. Please refer to the

following table for configuration (download) cable requirements.

HMI Model

Ethernet

Configuration

Cable

P/N 7431-0104

USB

Configuration

Cable

P/N 7431-0115

HMI5043N, HMI5056N, HMI5070NH,

HMI5100N

HMI5070TH/ETH, HMI5100T, HMI5104TH

HMI5043T, HMI5104XH, HMI5121X,

HMI5150X

Ethernet

If using a switch or router between the PC and the HMI, use a straight-

through or crossover cable as required by the switch or router.

USB

A USB driver (included with the EZware-5000 software) must be

installed when downloading from the PC to the HMI via a USB

connection. To install the USB driver, please refer to the help file ‘How

Do I’ section in EZware-5000 for detailed step-by-step instructions.

Note: When connecting two powered devices, a difference in potential can

exist between the ground reference on each device. If there is a difference in

ground potential (voltage), making a connection via a USB cable can

complete a ground loop that may damage the HMI and PC. We recommend

using the Maple Systems USB Configuration Cable (P/N 7431-0115) to

connect the HMI to the PC. The shield is not connected between the two

ends of the cable, which will prevent a potentially damaging ground loop

from occurring between the devices. Please refer to page 5 for proper wiring

instructions.

1 2 ... 8 9 10 11 12 13 14 15 16

Pas de commentaire

Maple-systems HMI5000 Series Manuel d'utilisateur Page 13