Maple-systems HMI5000L Series Manuel d'utilisateur télécharger pdf (Page 11)

HMI5000L Installation Guide 11

1010-1018 Rev 01 www.maplesystems.com

 Run AC power wires in a separate grounded conduit to reduce

electrical noise interference.

 Keep the cable lengths for the HMI as short as possible. Do not

coil excess cable and place it next to AC powered equipment.

 Cover any equipment used in the enclosure that operates at high

frequency or high current levels with a grounded metal shield.

Installation

It is necessary to follow all installation procedures described in this

chapter for electrical noise immunity and CE compliance.

Your Maple Systems HMI is designed to connect easily to your PLC.

External rear connectors provide quick connections for power,

communications and programming wiring.

Connect the HMI to Power

Use the separate 3-position terminal block supplied with the HMI to

provide power to the HMI.

The power cable for the HMI should be 18AWG, 2-conductor wire with

a shield drain wire and protective shield (foil/braid). You may buy cable

P/N 6030-0009 by the foot from Maple Systems to make your own

power cable.

Always run the DC ground wire directly back to the signal return of the

power supply. Do not use the chassis ground wire as your signal return.

Caution: To prevent possible damage to the HMI, we

recommend waiting ten seconds after removing power to the

HMI before applying power again.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Maple-systems HMI5000L Series Manuel d'utilisateur Page 11