Maple-systems HMI5000L Series Manuel d'utilisateur télécharger pdf (Page 13)

HMI5000L Installation Guide 13

1010-1018 Rev 01 www.maplesystems.com

3. Install the power supply wires as follows (with colors shown for

Maple Systems cable P/N 6030-0009):

Color

Power Supply

HMI

Red

+Output/+24V DC

+24 V

Black

–Output/+24V DC return

GND

Shield

Case ground

FG or

NOTE: The power connector on the HMI5000L Series uses a 3-position

terminal block with screw-down clamps. Lugs are not required.

Panel Preparation

A metal panel or mounting surface with a minimum thickness of 15

gauge (0.059 in/3.3 mm) if cold-rolled steel or hardened steel, or 10

gauge (0.101 in/2.6 mm) if aluminum alloy (6061-T6 preferred) is

required. Thinner panels or surfaces may bow between the mounting

clamps and not form a seal with the gasket. Make sure all supplied

mounting clamps are used and that the panel does not flex or bow more

than 0.010 in. to ensure a proper seal.

The HMI should be mounted into a panel with a depth of at least 4 in.

(105 mm). Allow a clearance of at least 1 in. (25 mm) on each side for

mounting hardware. Consider proper clearance for cable connections

when mounting.

NOTE: Cutout dimensions for each particular HMI model are readily

available for download from the Support Center-Dimensional Drawings

section of the Maple Systems website.

The area of the panel or mounting surface where the gasket comes into

contact must be flat and free of scratches, pits, and other features that

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Maple-systems HMI5000L Series Manuel d'utilisateur Page 13