Maple-systems HMI5000 Series Manuel d'utilisateur télécharger pdf (Page 50)

44 EZware5000 Series Programming Manual

1010-1007, Rev. 10

4. Click OK and place the Set Bit Object on the window. It will appear as a square frame. Click on the screen to

deselect it, then double-click on it to reopen the properties (or right-click on it and select Attribute). Click the

Profile tab and set the Width and Height to 65 (pixels). Click OK to accept the new Profile settings.

5. Move the Set Bit Object over the Arrow Up button.

6. Copy and paste the Set Bit Object and place the second one over the Arrow Down button. When the Up or

Down buttons are pressed, the pump and pipe will change states to indicate that they are on.

Finishing Up

There are still a few more steps to finish your first project. In this section, you will:

 save the project onto your computer hard drive

 compile the project into a format that can be understood by the HMI

 run the offline simulator to test the project

 download the project to the HMI

 verify that the HMI operates as expected

 exit the EZware-5000 software

Saving your first project

1. From the File menu, click Save As. The Save As dialog box appears.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 201 202

Pas de commentaire

Maple-systems HMI5000 Series Manuel d'utilisateur Page 50