Maple-systems HMI5000 Series Manuel d'utilisateur télécharger pdf (Page 119)

Using EZware-5000 113

1010-1007, Rev. 10

Off-line Simulation

Opens a compiled project (*.xob) in off-line simulator mode.

Pass-through mode

The pass-through mode allows serial communications from the PC to the PLC, though the HMI. This can eliminate the

need to disconnect the PLC from the HMI when it is necessary to configure the HMI.

To use the serial pass-through mode:

1. Select COM port. In the serial pass-through mode, data coming in on one serial port on the HMI is re-

transmitted out another serial port to the PLC.

2. HMI/IP: If the HMI has an Ethernet port, Project Manager can query the HMI to get its communication

parameters through the Ethernet port. Specify the IP Address of the HMI that is to be used in pass-through

mode and click Get HMI Communication Parameters to read the current communication settings for the

HMI (if the HMI is connected directly to the PC’s Ethernet port, you must use a crossover Ethernet cable).

3. HMI work mode: Indicates the current mode of the HMI. After the communication parameters have been

received, the mode will be either Normal (HMI set to communicate with PLC) or Pass-through (HMI is in

pass-through mode).

4. Source COM Port (PC -> HMI): Set COM settings for the HMI COM port that will be connected to the PC.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 201 202

Pas de commentaire

Maple-systems HMI5000 Series Manuel d'utilisateur Page 119