Maple-systems HMI5000 Series Manuel d'utilisateur télécharger pdf (Page 132)

126 EZware5000 Series Programming Manual

1010-1007, Rev. 10

7. You will see a new entry that lists the PLC address that is monitored by the HMI.

The PLC must only enter window numbers that represent full size windows when using the PLC Control Object

function. The HMI automatically closes any open windows before the window called by the PLC Control Object is

displayed.

The Direct and Indirect Window Objects

If you want the PLC to call up a popup window that is to be overlaid on top of other windows already open, then

there are two methods used to do this:

• Direct Window Object

• Indirect Window Object

 Unlike the PLC Control Object, the Direct and Indirect Window Objects are only active for the windows into which

they are placed.

The Direct Window Object is used to display a popup window using a PLC coil. The HMI continuously reads the value

of the PLC coil to determine its state. If the trigger state is detected, then the predefined popup window is displayed.

The Indirect Window Object is used to display a popup window using a PLC data register. Similar to the PLC Control

Object, the HMI continuously monitors the selected PLC data register. It will display any popup window that

corresponds to the number placed into the PLC data register by the PLC.

The PLC must reference a window that is less than full size when using the Direct Window and Indirect Window

objects.

To call a popup window using the Direct Window Object:

1. From the Objects menu, select Direct Window. The New Direct Window Object dialog box appears.

2. Select the trigger state in the Trigger drop-down box (ON or OFF).

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 201 202

Pas de commentaire

Maple-systems HMI5000 Series Manuel d'utilisateur Page 132